Xantrex RV2012GS, Руководство пользователя

Страница: 32 / 64

Installation
2–14 975-0209-01-01
5. Connect the connector at the other end of this cable to one of the terminals on
the fuse or breaker.
6. Use a wrench to tighten the bolt to the torque recommended by the fuseholder
or breaker manufacturer.
7. Connect one connector on the other section of the POSITIVE (+) cable to one
of the terminals on the disconnect switch (or to the other terminal on the
breaker). Use a wrench to tighten the bolt to the torque recommended by the
fuseholder or breaker manufacturer.
8. Connect the connector at the other end of this POSITIVE (+) cable to the
POSITIVE (+) DC terminal on the battery. Use a wrench to tighten the bolt to
the torque recommended by the battery manufacturer.
9. Connect one connector on the NEGATIVE (–) cable to the NEGATIVE (–)
terminal on the battery. Use a wrench to tighten the bolt to the torque
recommended by the battery manufacturer.
Before proceeding, check that the cable polarity is correct: POSITIVE (+) on
the inverter/charger is connected to the POSITIVE (+) on the battery, and
NEGATIVE (–) cable is connected to the NEGATIVE (–) terminal on the
battery.
10. Place the ring terminal of the NEGATIVE (–) cable over the bolt and directly
against the inverter’s battery terminal. Place a lock washer over the terminal.
Do not place the lock washer under the cable terminal. Figure 2-5.
Use a wrench to tighten the nut to a torque of 12 ft-lbs (16.3 Nm).
11. To protect the DC terminals, attach the supplied DC terminal covers, using the
screws provided.
Figure 2-5 DC Cable Connection
Note:
Connecting the battery cables to the inverter battery terminals will cause an arc,
usually accompanied by a “snap.”