![background image](http://html.mh-extra.com/html/xantrex/gateway/gateway_installation-manual_881373047.webp)
Using the Configuration Web Page
975-0330-01-01
3–13
Subnet Mask
Enter the bits in the IP address which are used to refer to
devices on the local network.
If your home router cannot supply addresses to devices on the network, or
if you want the Gateway to have a specific address, clear the Get Address
Dynamically check box and enter a mask here.
Domain Name
Enter a name for the Gateway and the networked power
system.
This is the name your power system uses on the network to identify itself
to other computers. It is included in all email sent from the Gateway. The
default domain name is POWERSYSTEM. This name also appears in the
list of auto-detected IP addresses on the Solar Monitor Widget.
After clicking Save and Apply, the Xantrex Gateway reboots with new
settings and does not reply for about a minute. This configuration page
will attempt to reload with the IP address you set. If the configuration
page does not reload, re-enter the IP address of the Gateway in your web
browser’s address bar.
Configuring Wireless Mode
When configuring wireless network parameters, you must enter as much
identical information from your existing network as possible. Before
configuring wireless mode, view and record the network wireless settings
you are using with your router or computer.
If the Gateway loses connection while configuring wireless mode, the
Gateway may have to be reset. Follow the procedure described in
“Resetting the Gateway to Factory Defaults” on page 3–21. Before
resetting the Gateway, ensure that the Gateway and your computer are
connected with an Ethernet cable.
Network Interface.
Configures the Gateway to use either a wireless or
a hard-wired Ethernet connection for the communications network. Select
“Wireless” or “Wired.”
Network Type.
Configures the type of wireless connection between the
Gateway and your computer. When a wireless router is the connection
point between the computer and the Gateway, select “Infrastructure.”
Most installations will use “Infrastructure” mode. For a direct connection
between the Gateway and a wireless-equipped computer with no
connection to the Internet (see Figure 1-8 on page 1–7), select “Ad-Hoc.”
“Ad-Hoc” networks also require a radio channel to be set.
www.xantrex.com.ua
Содержание Gateway
