- 11 -
REPLACING THE FUSE
1. Unplug the power cord from the outlet.
2. Remove the fuse compartment by using a Phillips head
screwdriver to unscrew the fuse holder (found right above the
power receptical on the back of the unit).
3. The fuse that is in use will be in the fuse clip. If the fuse is
damaged, replace it with the new fuse.
4. Insert the fuse compartment back into the unit and tighten with the
Phillips screwdriver.
TROUBLESHOOTING
ISSUE
POSSIBLE SOLUTIONS
Unit does not
have power
• Ensure the power cord is securely plugged into the
outlet.
• Ensure that the outlet is functional.
• Contact X-Tronic International for assistance -
Contact information on back of manual
Soldering Iron
“Rattles”
• This is expected behavior. The “rattle” is a small ball
that allows the unit to determine when the soldering
iron is not in use and it should go into Sleep Mode.
S-E Error
• Ensure the hot air gun is securely plugged into the
front of the unit.
• The heating element may need to be replaced.
• Contact X-Tronic International for assistance -
Contact information on back of manual
Note: When using a temperature higher than 300°C/572°F on the
hot air gun the air flow should be set at 45 or higher. This
will prevent damage to the hot air gun and increase the life
of the heating element.
