- 4 -
INITIAL SET-UP
1. Plug the Hot Air Gun into the front cord receptacle on the lower left
side of the unit and tighten the ring nut.
2. Place the hot air gun into the holder on the right side of the unit.
3. Plug the 3-Prong AC cord into a 110/120V grounded outlet to
prevent electric shock or injury.
4. Turn on the power switch for the hot air gun in the lower right on
the front of the unit. When the unit is first turned on “C - C” or “F -
F” will briefly show on the top display to indicate if the unit readouts
are in Celsius or Fahrenheit respectively. Then both LED displays
will show “---”.
5. The top display will show “---” when the hot air gun is in its holder
and in standby mode.
6.
Push the Hot Air Temperature Adjustment Buttons (▲ or ▼ ) in the
middle of the unit to set the temperature.
7. Turn the Air Flow Control Knob to adjust the airflow for the hot air
gun. This can be set from 20 - 100.
CAUTION
When using a temperature higher than 300°C on the hot air gun the
air flow should be set at 45 or higher. This will prevent damage to
the hot air gun and increase the life of the heating element.
8.
When the hot air gun is removed from the holder it will start
blowing air and ramp up to the programmed temperature and air
speed quickly.
9. When the hot air gun is not in use always place it back in the
holder. When the hot air gun is placed in the holder, it will start
going into the Auto Cool Down and Standby mode immediately.
The hot air gun will continue blowing air until the temperature gets
back down to 100°C and then the airflow will stop and the hot air
gun will go into standby mode.
Note:
When the hot air gun is initially returned to the holder, the air flow
may increase noticeably while the hot air gun is cooling down and
going into standby mode. This is a safety feature built into the
unit.
