X-FIRE 1200 Limestone, Инструкция по установке и эксплуатации

Страница: 44 / 48

630140_1 XFIRE_1200_GB _Service_R ‐ em otion
Once the con tro l unit cover has been removed the main gas connection, Valve to
Pilot tube, and Valve to Burner tubes shou ld be disconnecte d. Push the
thermocouple down from inside the firebox to disconnect from pilot asse mbly. Once
the two screws pictured above are removed the tray is free to be lifted (e nsuring that
all wiring is clear from sheet metal) up 15mm to clear the metal edge and pulled
towards you.
If the thermocouple needs to be replaced unplug from tray and unscrew from end of
valve. It can then be replaced with the replacemen t thermo couple. Ensure that the
replacemen t thermo couple is pushed fully home – This may requ ire substan tia l force.
A click shou ld be felt.
Other components on the control tray can be repla ced when necessary while tray is
separate from the firep lace.
When replacing the tray , make sure to reco nnect all gas pipes tigh tly and using
sealant wher e required.
6.0 Check Glass Assembly:
Check that the glass assembly (R emoved in section 3.0) for
damage to glass or sealin g tape. If the glass has any visible
damage it must be replaced befo re use.
Ensure the tape which seals the glass against the firebox
is in the correct posit ion (shown to the right) and that the
glass is secu re inside the metal frame and free from
movement.
7.0 Clean Pilot and Main Burner Jets:
With the burner removed the burner jet is now accessible. Remove the jet and clean
it using an approp riate method , such as using a micro drill or co mpresse d air.