X-FIRE 1200 Limestone, Инструкция по установке и эксплуатации

Страница: 42 / 48

630140_1 XFIRE_1200_GB _Service_R ‐ em otion
13.0 Re ‐ establish Power and Gas Connections
With all ap plicable service work completed and the fire fully assemble d again the gas
can be re ‐ establishe d and the batteries replaced .
Check gas inlet pressure against data plate at pressu re test point using a manometer.
Adjust gas pressu re to specifications.
Remove the manometer and replace the test point screw.
Leak test all test points and gas system joins/unions.
Check that the pilot flame correctly impinges on the flame failure device
(thermocouples shoul d not glow red, as this indicate s that the pilot flame is set too
high and will reduce the life of the thermocouple).
14.0 Re ‐ fit the Facia
The XFIRE facia uses these four hooks for attaching to the fire. Do this by lining up the
facia hooks with the receptacles on the sides of the fire. Lift the facia so that the
hooks are above the receptacles, and let it drop down into posit ion until it is secure
and free from movement.