X-FIRE 1200 Limestone, Инструкция по установке и эксплуатации

Страница: 21 / 48

630140_1 XFIRE_1200_GB_Manual_R ‐ emotion
12.13
Points to note when planning the Installation of the Escea DV flue:
- This flue system cannot be cut to length. Correct lengths must be selected for each
installation. For a full list of available flue lengths, contact your Escea retailer.
- The listed length of the flue pipe is not the installed length. 1 ½” (38mm) needs to be
subtracted for each join to determine the installed length of each piece of flue pipe.
E.g. 48” length has installed length of 45”.
- All vertical measurements should be measured from the top surface of the fireplace casing
itself (not the facia).
- When using horizontal flue runs, vertical measurements should be measured to the centre
line of the horizontal flue pipes.
- When using 90° elbows in the installation, use the diagram below to help calculate
installations horizontal and vertical distances. 1½” (38mm) will still need to be subtracted
from each join.
- If using a 45° offset in your installation, consult the chart below to select the required flue
length to give the desired offset. 1½” (38mm) will still need to be subtracted from each of
the 45° bends to allow for the joins.
- Adjustable lengths are available depending on stock levels. Contact Spec-Flue for more
information.
Straight
Flue Length:
Offset: Rise:
0”
5
5
/
8
” 15
3
/
8
”
6”
8
7
/
8
” 18
3
/
8
”
9”
10
7
/
8
” 20
5
/
8
”
12”
13” 22
5
/
8
”
24”
21
3
/
8
” 31
1
/
8
”
36”
29
7
/
8
” 39
3
/
8
”
48”
38
1
/
4
” 47
7
/
8
”