X-FIRE 1200 Limestone, Инструкция по установке и эксплуатации

Страница: 41 / 48

630140_1 XFIRE_1200_GB _Service_R ‐ em otion
15.0 Troublesh ooting
Use the following troubleshooting chart to diagnose and fault ‐ find operati on al issu es
with XFIRE 1200 deco rative gas fireplace s.
Problem Cause Error me ssage LCD displ ay Solution
Fire does not ignit e
No batteries or flat batteries in contr ol unit 10 beeps Battery error Place new batteries in contr ol unit
ROM error 2 cycles of 3 beeps ROM error change contr ol unit
Suppo rt test error 2 cycles of 5 beeps Suppo rt error Connect earth cable fro m battery box to valve
Bad recepti on of remo te handset signal
•
Change batteries in the remo te handset
•
Check rece ptio n of signal from a shorter
dist ance
•
Try making the pairing again
•
Try changin g the channel in the conf igur atio n
menu
No respon se to touch contr ol buttons .
Cable lose or bro ken or connected the wrong
way ro und
If LED is conti nuous ly
on, the cabl e is
connected the wrong
way ro und
•
Ensure the touch con tro l cable is corr ectl y
connected (see instal lation manual)
•
Change touch contr ol
Suppl y cable to valve disc onnected or bro ken 2 cycles of 5 beeps Suppo rt error Connect supp ly cable to valve
Spark cable disc onne cted, bro ken, not
attached corr ect
Connect spark cabl e
Fire does not ignit e in
progra m mode
Pro gra m mode does not work if soft start is
deac tivated
Active soft start
Sparks but no pilot
ignit ion
Gas suppl y off or no gas Check gas installation . Open gas valve
Valve cable disc onne cted or bro ken Connect valve cable correctly
ODS cable disc onnect ed or bro ken Connect corr ectl y or replac e ODS cable
Pilot ign ite s but does n’t
stay on
ODS is not warmed up Check pilot flame and verify that it heats the ODS
ODS cable badly con nected Change pola rity of ODS cable
ODS cable disc onnect ed or bro ken Connect ODS cabl e
Ignites commandi ng
from remot e hand set
but not from touch pad
Touch contr ol cable dis co nnected or bro ken Connect or replac e to uch contr ol cable
Defective touch cont ro l buttons Change touch contr ol
Ignites commandi ng
from touch pad but not
from remot e hand set
Bad communi catio n with handset
•
Change batteries in the handset
•
Check rece ptio n of signal from a shorter
dist ance
•
Try making the pairing again
•
Try changin g the channel in the conf igur atio n
menu
Fire switch es off afte r 6
seconds
Sh ortcut in touch con tro l 5 beeps Button error Change touch contr ol wiring
Low batter ies in the
remote
Low battery Change batteries in the remo te
Fire switch es off
2 cycles of 3 beeps Conf ig error Change contr ol unit
2 cycles of 3 beeps Eepron error
•
Try making the pairing again
•
Change contr ol unit
Loss of communi catio n between applia nce
and remo te for 18 min
20 beeps
•
The remo te is too far from the applia nce
•
The remo te has no batteries
High temperature on the contr ol unit 1 long beep Temp error If this occur s more than once call the techn ical
service
Ambi ent temperature higher than conf igur ed Over temperature Check corr ect conf igur atio n of safety temperature