Wunder Audio Wunderbar Super D, Руководство по эксплуатации

Страница: 8 / 31

Routing Module
A
48 Volt/Phantom Power
- on/off switch
B
Trim (Direct Out) Knob - The second of two active
gain stages. This is essentially a fade before the output
amplifier in the PEQ2.
Although housed in the routing module, it is completely
independent from the routing electronics. The VU meter
displays the level of whatever is plugged into the input
of the routing module.
This knob is very unique to the Wunderbar. Unity Gain is
just slightly before the 3 O’clock position. When making
boost and cuts to the EQ this knob can be adjusted to
achieve zero dB at the VU meter for unity gain. Not
enough can be said about lowering this knob below
unity gain and turning up the PEQ2 Line input knob
during mix down to achieve a different more distorted
color.
C
Flip Switch - Swaps the trim knob and the P&G
100mm conductive plastic channel fader .
This allows
the user to “ride” the trim via the channel fader during
tracking if desired.
D
Auxiliary Sends 1-4 - Send signal from the I/O module
(channel strip) to the corresponding aux master knob
(rotary fader) in the
master section .
Pre/Post switch determines whether the auxiliary signal
is before or after the channel fader.
When sending signals to headphones, putting this
switch in the pre-fade position will allow the headphone
levels to be independent of the fader being used to
monitor levels on the console. During a mix, setting this
fader to post mode will conform its output to an effects
device in proportion to the fade being used in the mix.
Wunderbar Super D User's Manual Rev. 1, Dec. 2018
8