Wunder Audio Wunderbar Super D, Руководство по эксплуатации

Страница: 19 / 31

Installing the Wunderbar Stand
Install the stand before you install the PEQ2 modules so the frame is lighter.
1) Place the desk on a carpet or blanket and tilt back the desk so the armrest faces
upwards and the rear/back panel (just above the XLR' s) of the desk is on the floor
(never lift the desk by the armrest.)
2) Install one of the two “Stand Feet” to the far left part of the bottom of the desk
using 2 of the 4 inch bolts (included). When doing this, have someone hold all the
weight of the end foot so there is no stress on the screw threads. Do not tighten all
the way.
Place a small wood block in between the stand foot and the floor so the end foot
does not hang all its weight on the two loose screws.
3) While leaving the left stand foot about 1/16" loose, as in the last step, place one
of the 2" x 3” “Frame Struts” over the square stand foot guide. Examine the holes at
either end of the frame strut and note that one hole is smaller and threaded, this hole
goes upwards so that it is against the bottom panel of the desk.
Attach the frame strut to the bottom on the desk with the long bolts. Do not tighten all
the way.
4) Carefully thread the 3" bolt into the left end of the frame strut, through the stand
foot guide and back into the treaded top on the frame strut.
5) Repeat step 3 & 4 with the 2nd frame strut.
6) Tighten all long bolts in the frame struts and left end foot.
7) Install the 2" x 3" bottom frame strut.
8) Install the right stand foot and tighten bolts.
Wunderbar Super D User's Manual Rev. 1, Dec. 2018
19