11.Double heads printing position calibration
* Double printheas printing calibration is limited to two printheads machines.
This calibration is to adjust the two heads printing coincidence from right to
left, left to right and front to back.
When moving printhead or re-install the driver, it is necessary to take this
operation.
1.
Press [MENU]，use [ ] to choose HEAD1-HEAD2, press [ ] to enter, and use [ ] to
choose print modes: printing from left to right or from right to left.
2.
Press [ ] to select printing mode from right to left, press [ ] to enter
RIGHT_LEFT submenu, press [ENTER] to start test printing.
3.
Press [ ] to enter test printing interface, press [ENTER] to start test printing.
Current value
No deviation value
7 6 5 4 3 2 1 0
10 9 8 7 6 5 4 3
2 1 +0- 1 2 3
4 5 6 7 8 9
Test result
4.
Check test printing result on the right and choose a value without deviation,
note“+”“-”, in this case without deviation value is“+1”.
Head1-Head2(R-L)
HEAD1-HEAD2(RL)
TEST PRINT B
HEAD1-HEAD2(RL)
TEST PRINT B
ENTER
MENU
26
