10.Printhead Bi-direction calibration
* Only required when the print direction is set to be [BI_DIRECTION] under [PRINT QUALITY].
This adjustment is for bidireciton printing offset adjustment.
This operation should be carried out when you change media, or printhead height is adjusted.
1.
Press [MENU] and [ ]，to select BIDIRECTION.
2.
Press [ ] to enter BIDIRECTION submenu.
3.
Press [ENTER] to start print test.
BIDIRECTION-------1
TEST PRINT B
MENU
BIDIRECTION
TEST PRINT is print mode choose.
B mode is for verticle print, C mode
is for horizental print.
Current value
Test result
7 6 5 4 3 2 1 0
10 9 8 7 6 5 4 3
2 1 +0- 1 2 3
4 5 6 7 8 9
10
No deviation value
4.
Check the results of the test print on the right and select a no deviation
value, note that“+”“-”，in this case no deviation value is“+2”.
5.
Press [ ] to enter mode 1 interface, press [ ] to enter initial setting
interface.
BIDIRECTION-------1
ADJUST +7
MENU
24
