wtw pH 3210, Руководство по эксплуатации

Страница: 75 / 78

pH 3310 Appendix: Firmware update
75 ba75802e02 12/2008
Appendix: Firmware update
General information Available firmware updates are provided on the Internet.
With the "Firmware Update " program and a PC you can update the
firmware of the pH 3310 to the newest version.
For the update you have to connect the meter to a PC.
For the update via the USB interface, the following is required:
z
a free USB interface (virtual COM port) on the PC
z
the driver for the USB interface (on the enclosed CD-ROM)
z
the USB cable (included in the scope of delivery of the pH 3310).
Program installation
Program start
Firmware update
After switching the meter off and on you can check whether the meter
has taken over the new software version (see page 65).
1 Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the meter (or meter type),
the new data is displayed there.
2 In the windows start menu, open the update folder and start the
firmware update program.
3 Using the USB interface cable, connect the pH 3310 to a USB
interface (virtual COM port) of the PC.
4 Switch on the pH 3310.
5 In the firmware update program, start the update process with
OK.
6 Follow the instructions of the firmware update program.
During the programming process, a corresponding message
and a progress bar (in %) are displayed.
The programming process takes approx. three minutes. A
terminatory message is displayed after a successful
programming process. The firmware update is completed.
7 Disconnect the pH 3310 from the PC.
The pH 3310 is ready for operation again.