WTE TReX-460, Руководство пользователя

Страница: 154 / 302

TReX User Manual v15.30 Firmware
RAW Protocol
The Raw protocol uses all default settings to determine the data rate, transport method, cap
code etc. This protocol is the protocol used when using a point to point serial link.
Default transmission settings are configured with the commands:
*TX_BAUD
*TX_CAP
*TX_LEVEL
In addition, the following commands are used with RAW protocol:
*RAW_TIMEOUT
Specifies the time of inactivity in 25ms steps before sending all stored data (max 255),
example for a timeout of 100mS:
Typical usage:
*RAW_TIMEOUT=4<CR>
*RAW_END
Specifies a character that results in immediate transmission, or displayed after reception (0 if
unused). Decimal value of ASCII character.
Typical usage: .
*RAW_END=13<CR>
This means transmit immediately after the carriage return character is seen. Also after
decoding each message, the carriage return character is also displayed.
*RAW_CONFIG
Specifies all RAW protocol parameters.
Parameter 1 specifies the time of inactivity in 25ms steps before sending all stored data
(max 255).
Parameter 2 specifies a character that results in immediate transmission (0 if unused).
Decimal value of ASCII character,
Typical usage:
*RAW_CONFIG=4,13<CR>
© WTE Limited, 2022 – Christchurch New Zealand
Page 154 of 302