WTE TReX-460, Руководство пользователя

Страница: 101 / 302

TReX User Manual v15.30 Firmware
operating temperature and NOT the ambient temperature.
MAINS FAIL
When ENABLED, an alert will be raised when a MAINS FAIL event has been detected.
Alert is raised when “MAINS FAIL” is seen in the payload of an input message. Alert is
cleared when “MAINS RESTORED” is seen in another input message. A typical application
for this is to connect a plug pack to provide a voltage source to an input. The input HIGH and
LOW messages would be configured with “WT0000000A10 MAINS_FAIL” and
“WT0000000A10 MAINS_RESTORED”.
RF ERROR
When ENABLED, an alert will be raised when an RF ERROR has been detected.
Alert is raised when there an antenna mismatch or low power condition at the beginning of a
transmission.
BATT
When ENABLED, an alert will be raised when low BATT voltage has been detected.
Alert is raised when the system voltage is below the minimum BATT input voltage threshold.
ALERT REPEAT
When DISABLED and SYSTEM->SOUND is ENABLED an alert will result in a single
audible indication. This is the seconds between repeated alert beeps that will repeat until the
alert has been acknowledged either by pressing the ENTER button, cycling power or auto-
clearing as described in
Alert Handling .
ALERT OUT
When set to an output from 1-8, this is the output that can be operated when ANY alert is
raised.
SOUND
Enables sound for alerts and key presses.
© WTE Limited, 2022 – Christchurch New Zealand
Page 101 of 302