4Yc`\Qi=_TU
#$
45@! C4QdQ5^dbi@Q^U\
Note:
The display you see may vary based on the WCU selected. For
example, if your WCU does not calculate KVAT, you will not
see the KVAT values. Similarly, previous versions of the DEP-
100S software show primary voltage as LINE(V) and primary
current as SEC(I).
8UQd4Yc`\Qi
The Heat Display is used to adjust the cycle times for certain
functions (such as squeeze, weld and hold) and the amount of
weld energy, without changing the weld schedule (in Program
Mode). This lets you experiment with different weld times and
heats, to weld a series of test coupons.
When you press
for
HEAT DISPLAY
, the DEP-100S displays
these functions from the selected weld schedule using an
abbreviated format.
A sample Heat Display (for a dual-pulse weld) is shown below.
This shows that schedule #1 of weld device #00 provides 99
cycles of squeeze (SQUZ) time, then weld for 8 cycles at 20% heat
using automatic voltage compensation firing mode and finally
hold for 5 cycles.
88D" 3?==?>
94( ( CAEJ))G<4 (3" 8?<4 %
gSe cSX !T_g^\_QT
6!6"6#6$
Содержание DEP-100S
Страница 2: ...ii...
Страница 39: ...b_WbQ _TU 45 C 4QdQ 5 dbi Q U Caution Every device must have a unique address on the network...
Страница 40: ...b_WbQ _TU 45 C 4QdQ 5 dbi Q U...
