WINGLINE
MOUNTING INSTRUCTIONS
9
8
July 2014 Misprint and technical changes reserved. © by WO&WO Art.-Nr.: 930113_DE
WWW.
WoundWo
.COM
3.
initial operation
Before the initial operation of the awning, remove all objects (e.g. ladders, tools etc.) from the full travel range
(in/out) of the awning and from underneath the awning. During the trial operation, ensure that nobody is in this
area – there is a risk of injury in case of a malfunction.
For trial operation, always use the test cable (no automatic control units etc.). In addition, the operator must be
able to see the awning.
The end position switches of the motors are factory set. However, readjustments on location pursuant
to Item 3.2. are required.
Fully extend awning and check switch-off point.
In fully extended condition, the awning is optimally stretched. When winding up the awning for the first time,
check that the covering is wound up properly and that the articulated arms fold correctly (parallel).
Electrical installation work and connections to the mains must be carried out exclusively by a licensed
electrical company.
3.1. adjusting the inClination/headroom
The awning is prebuilt in the factory with approximately
0° inclination. If a steeper adjustment of the awning is desired,
please proceed as follows:
Adjustment of the arm inclination:
•
Extend awning approximately half way.
•
Remove the covers of the pivoting part.
•
Remove securing screw with SW 5 Allen key.
•
Lift arm slightly to relieve the load on the pivoting
part and adjust the inclination by turning the screw
with SW 10 Allen key.
Turning clockwise
→
Awning is lowered
Turning counter/clockwise
→
Awning is raised
When letting down the arm, ensure that the pivoting part rests
with its surface on the head of the countersunk screw.
•
In the event of a significant change of the
inclination setting (more than 10°), the arms must
be adjusted alternately.
•
Once the desired inclination is achieved, check that the
drop profile is horizontal. If applicable, correct slightly.
•
With the securing screw, secure the arm inclination and
refit the covers.
•
Adjust the second side of the awning in the same manner.
The table below specifies the approximate headroom for diffe-
rent inclination settings, post heights and extended lengths.
