WINGLINE
MOUNTING INSTRUCTIONS
11
10
July 2014 Misprint and technical changes reserved. © by WO&WO Art.-Nr.: 930113_DE
WWW.
WoundWo
.COM
3.4 Completing the installation / transfer to the Client
•
Clear site. Remove packaging materials from site and dispose according to local regulations.
•
Hand over to client all instructions concerning the installation and operation of the awning as well
as the instructions for the electrical connections of control units and switches.
Give client comprehensive instructions about the operation of the awning. Failure to observe the
instructions and incorrect operation can result in damages to the awning and accidents.
Notify client of the wind resistance class of the awning.
4.
dismounting the aWning
Ensure that the area around the awning is free of unauthorised personnel. De-energise awnings with driving gear
and secure against accidental switch-on.
•
Dismount the awning exclusively in retracted condition.
•
Dismounting of the awning is the reverse of the mounting procedure
Type of defecT
cause
Remedy
Driving gear does not work
No power
Check connection (specialised company)
Driving gear not correctly connected
Check connection (specialised company)
Thermal protection of the driving
gear activated
Wait for 15-20 mins, then operate again
Remote control batteries empty
Check light signal on sending unit,
replace batteries
Higher-level control unit prevents
manual operation
Wait until higher-level signal is not activated
any more.
System does not extend or
retract fully
End positions of the driving gear chan-
ged, or incorrect end position setting
Reset or re-program end positions (see
instructions about driving gear adjustment)
Awning makes grating noises
Insufficient lubrication
Spray arm articulation bearing with a
suitable lubricant (e.g. Teflon spray)
Arms do not fold parallel or are
under load
Drop bar holder positioned incorrectly Move drop bar holder along drop profile as
necessary
5.
troubleshooting
3.3. mounting the roof
•
The awning is in the back end position.
•
Place the premounted roof from above onto the
links of the side parts.
•
Screw the roof to the side parts.
In the version with 2 posts, use 4 screws each on
the fronts of the side parts.
In the version with 1 post and wall connection on the
free side, use 4 countersunk screws at the front of the
side part. On the wall side, insert 4 rounded head
screws from the top through the predrilled fixing
positions of the roof profiles.
