14
AFTER SALES SUPPORT
1300 855 831
MODEL: DP17L PRODUCT CODE: 53664 08/2018
AUS
Safety regulations
DP17L
–
Check whether the moving parts function faultlessly and do not jam or
whether parts are damaged. All parts must be correctly mounted and all
safety conditions must be fulfilled to ensure fault-free operation of the elec
-
tric tool.
–
The moving protective hood may not be fixed in the open position.
–
Damaged protective devices and parts must be properly repaired or
replaced by a recognised workshop, insofar as nothing different is specified
in the operating manual.
–
Damaged switches must be replaced at a customer service workshop.
–
Do not use any faulty or damaged connection cables.
–
Do not use any electric tool on which the switch cannot be switched on and
off.
19
ATTENTION!
–
The use of other insertion tools and other accessories can entail a risk of
injury.
20
Have your electric tool repaired by a qualified electrician
–
This electric tool conforms to the applicable safety regulations. Repairs may
only be performed by an electrician using original spare parts. Otherwise
accidents can occur.
21
Do not use the cable for purposes for which it is not intended
–
Do not use the cable to pull the plug out of the outlet. Protect the cable from
heat, oil and sharp edges.
22
Remove adjusting key and wrenches
–
Form the habit of checking to see that keys and adjusting wrenches are
removed from the tool before turning it on.
ADDITIONAL SAFETY INSTRUCTIONS
•
Never make the warning labels on the power tool illegible.
•
Attach the power tool to a solid, flat and horizontal surface.
If the power tool can slip or wobble, the bit may not be guided smoothly and safely.
•
Keep the work area clean except for the workpiece to be machined.
Sharp-edged drilling chips and objects can cause injury. Material mixtures are
particularly dangerous. Light metal dust can burn or explode.
•
Set the correct speed before starting work. The speed must be appropriate
for the drill diameter and the material to be drilled.
At an incorrectly set speed the bit may get jammed in the workpiece.
•
Only when the device is turned on should the bit be moved against the work-
piece.
Otherwise there is a danger that the bit will get jammed in the workpiece and the
workpiece will rotate with the bit. This can lead to injuries.
•
Do not put your hands in the area of the drill while the power tool is running.
Upon contact with the bit is a risk of injury.
•
Never remove drilling chips from the drilling area while the power tool is
