26
AFTER SALES SUPPORT
1300 855 831
MODEL: DP17L PRODUCT CODE: 53664 08/2018
AUS
Maintenance
DP17L
Disconnect the mains plug, and wait until the rotating tool stands still. All protection
and safety devices must be immediately re-installed once the repair and
maintenance work is completed.
Cleaning and Servicing
Pull the mains plug before any adjustments, maintenance or repair.
Have any work on the device that is not described in this instruction guide performed
by a professional. Only use original parts. Allow the device to cool off before any
maintenance or cleaning is undertaken.
There is a risk of burning!
Always check the device before using it for obvious defects such as loose, worn
or damaged parts, correct the positioning of screws or other parts. Exchange the
damaged parts.
Cleaning
Do not use any cleaning agents or solvents. Chemical substances can etch the plas-
tic parts of the device. Never clean the device under running water.
•
Thoroughly clean the device after every use.
•
Clean the ventilation openings and the surface of the device with a soft brush or
cloth.
•
Remove chips, dust and dirt with a vacuum cleaner if necessary.
•
Lubricate moving parts regularly.
•
Do not allow lubricants to come into contact with switches, V-belts, pulleys and
drill lifting arms.
Recommendations:
Slightly relubricate the movable parts of the table and the bend tensioning device.
•
We recommend that you clean the device immediately each time you have fin
-
ished using it.
• Regularly check the guiding rollers and the support bearings. If required, readjust
or disassemble them, and grease or exchange the parts.
• Exchange wornout table inserts.
• Ensure that the working table is always free of resin.
• Keep all safety devices, air vents and the motor housing free of dirt and dust as
far as possible. Wipe the equipment with a clean cloth or blow it with compressed
air at low pressure.
