2
Assemble & disassemble battery pack
Align the battery pack with the slide slot on machine rear body.
Insert the battery pack into the machine slot. Then push it
completely. After hear one click sound, it means finished the job.
To remove the battery pack, just press down the knob on battery
pack and pull out it.
Assemble the stand
Align the holes in stand and foot, screw and fasten with the screw
knob comes with the light. See fig on first page.
Fastening to the tripod
You can use the tripod mount to screw the cordless work- light
onto a tripod. Make sure the tripod screw is M8.
Tighten the screw. Ensure that the tripod has a firm footing.
Switching On and Off
There is a on/off switch on back of the housing. To
start the cordless worklight, press the On/Off switch to
I or II position. To switch off the cordless worklight,
press the On/Off switch to
“O” position.
As difference working conditions requierment, the LED
light equipped with 2 working stages (I and II). First
stage is a low brightmess for small working area, and
second stage is high brightness for big working area.
WARNING! Do not stare the LED light beam, it
will hurt your eye.
MAINTENANCE
The light source cannot be replaced. If the light source is defective, the entire cordless worklight has to be replaced.
When the battery is no longer operative, please refer to an au- thorised after-sales service agent for the light.
The cordless worklight is maintenance-free and contains no components that must be replaced or maintained.
To avoid damage, clean the plastic lens of the cordless work- light only with a dry, soft cloth. Do not use cleaning agents or
solvent.
TRANSPORT
The contained lithium-ion batteries are subject to the Dangerous Goods Legislation requirements. The user can transport the
batteries by road without further requirements.
When being transported by third parties (e. g.: air transport or forwarding agency), special requirements on packaging and
labelling must be observed. For preparation of the item being shipped, consulting an expert for hazardous material is required.
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and pack up the battery in such a
manner that it cannot move around in the packaging. Please also observe possibly more detailed national regulations.
ENVIRONMENT PROTECTION
In order to prevent the machine from damage during transport, it is delivered in a sturdy packaging. Most of the packaging
materials can be recycled. Take these materials to the appropriate recycling locations. Take your unwanted machines to your
local dealer. Here they will be disposed of in an environmentally safe way.
Li-ion batteries can be recycled. Deliver them to a disposal site for chemical waste so that they can be recycled or
disposed of in an environmentally friendly manner.
Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively
support us in conserving resources and protecting the environment by returning this appliance to the collection
centres (if available).
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents:
EN60598-1:2015; EN60598-2-4:1997; EN60598-2-5:2015; EN62493:2015, EN55015:2013+A1:2015, EN61547:2009, EN61000-
3-2:2014, EN61000-3-3:2013.; in accordance with the regulations, 2014/30
/ЕU, 2014/35/EU.
