5
3. Installation
Your WOODWAY slat-belt treadmill will either be delivered to you fully assembled or else it will be assembled at
your location by our delivery agent. Please check the slat-belt treadmill for transportation damage immediately
upon receipt of delivery and report any damage immediately to the delivery agent and/or to your sales
representative.
3.1 Location
The slat-belt treadmill must be installed on a flat floor sufficiently capable of bearing a load.
Due to the moving parts on the underside of the slat-belt treadmill, it should not be placed on higher-than-average
pile floor covering. If necessary, a floor mat can be laid underneath. This will reduce the accumulation of lint inside
the slat-belt treadmill and it will also protect the floor covering from undue wear.
Due to the weight of the LokoStation with treadmill, (ca. 1,764lbs.) the ceiling, or the floor, should have the
necessary support capability or the treadmill should be put in a place where there are positioning points for
adequate support. The advice of a structural engineer is recommended.
3.2 Main power connection
Please observe the safety instructions at the beginning of the operation manual
Connect the power cable to the female connector at the lower right hand side of the slat-belt treadmill and insert
the other end into a properly grounded and adequately protected electrical socket.
At the highest speed, the maximum power consumption is 6 A at 230 V AC.
3.3 Ambient conditions for standard operation
Temperature:
+10° C to +40° C
Relative humidity:
15% to 85% non condensing
Air pressure:
700 hPa to 1060 hPa
Operation allowed in enclosed and/or roofed-over spaces only.
