13
4. Control lamp (the treadmill is currently in stop mode)
5. “Manual operation via handrail-mounted keypad” control lamp
6. Inclination / Pulse rate display element (alternating)
7. Elapsed time display element
8. Reset
button
9. Distance / Energy display element (alternating)
10. Speed display element
11. Button for changing displayed units of measure
6.2.1 Switching the treadmill on
The magnet must be properly positioned on the required field (2)!
After you have powered up the treadmill with the main ON/OFF switch located under the right side (as viewed
from the running direction), activate the treadmill by pressing the Standby Button (1). To stop the treadmill, please
use the “Stop button” on the handrail-mounted keypad.
6.2.2 Using the handrail-mounted keypad
a) Speed
adjustment
Start the treadmill by pressing the green “+ button”. The treadmill then runs with no resistance whatsoever and at
very low speed. To increase speed, press the "+ button" several times in succession or hold it down until the
desired speed has been reached.
To slow down, press the blue “- button”. Speed will diminish gradually. You can either press this button several
times in succession or hold it down continuously until the desired speed has been reached.
To stop more quickly, use the red “Stop button”. Pressing it once briefly causes the treadmill to stop relatively
suddenly. How quickly it stops depends on the speed with which it is running at the time the button is pressed.
The faster you are running, the longer it takes to stop - in any case, the shut down speed is always comfortable
and under no circumstances is it too fast.
b) Inclination
adjustment
To activate the inclination (for running uphill or downhill, the latter being an optional feature), press the yellow
button for going uphill and the yellow button for going downhill.
c) Treadmill control mode display
Green LED
(3) lit:
Manual control via handrail-mounted keypad active
The slat-belt treadmill can be operated via the handrail-mounted
keypad.
Red LED
(4) lit:
The treadmill is in Stop mode
Red LED
(5) lit:
Remote control activated
The slat-belt treadmill is controlled by an external control device
(PC or peripheral device, e.g. ECG) via the RS-232 interface.
Manual control via the handrail-mounted keypad is disabled.
d) Reset button (8)
