Manual 37187A
SYNCONpanel - Transportable Remote Synchronizing Panel
Selector Switches
15
Frequency / Real
Power Control
Frequency / Real Power Control
↓
(lower)
....Decreases the frequency / real power control set point
↑
(raise)
.....Increases the frequency / real power control set point
16
Voltage / Reactive
Power Control
Voltage / Reactive Power Control
↓
(lower)
....Decreases the voltage / reactive power control set point
↑
(raise)
.....Increases the voltage / reactive power control set point
17
Busbar Sensing
Busbar sensing selection
Local
..........The busbar voltage is measured via the voltage measur-
ing inputs on the front of the SYNCONpanel.
Remote
......The busbar voltage is measured via the industrial plug-in
connector. The measuring inputs on the front of the
SYNCONpanel (Busbar L1 and Neutral N) are discon-
nected.
CAUTION
Observe the safety instructions in the SYNCONpanel cover!
Measuring Inputs
18
Current
Current measuring input
The clamp-on transducer must be connected here.
NOTE
If no clamp-on transducer is used, the current measuring input must be closed with a short-circuiting
termination to ensure a proper operation of the unit without a clamp-on transducer.
19
Voltage
Voltage measuring input
The voltage measuring lines must be connected here.
© Woodward
Page 19/27
