Woodstock ShopFox W1763W, Руководство пользователя, Страница: 50 / 64

-48-
Model W1763W (For Machines Mfd. Since 09/16)
SE
RV
IC
E
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Spindle does not
raise or lower
easily. 1. Spindle lock knob is tightened.
2. Dovetail ways are clogged with sawdust. 1. Loosen spindle lock knob ( Page 27).
2. Clean dovetail ways and apply lubricant (
Page 43).
Workpiece is
burned when cut. 1. Dull cutter.
2. Too slow of a feed rate.
3. Incorrect spindle speed.
4. Pitch build-up on cutter.
5. Cutter rotating in the wrong direction.
6. Taking too deep of a cut. 1. Replace cutter or have it professionally sharpened.
2. Increase feed speed.
3. Use correct pulley spindle arrangement (
Page 26).
4. Clean cutter with a blade and bit cleaning solution.
5. Reverse the direction of the cutter rotation.
6. Make several passes of light cuts.
Fuzzy Grain. 1. Wood may have high moisture content or
surface wetness.
2. Incorrect spindle speed.
3. Dull cutter.
1. Check moisture content and allow to dry if moisture
is more than 20% ( Page 23).
2. Use correct pulley speed arrangement (
Page 26).
3. Replace or have cutter professionally sharpened.
Chipping. 1. Knots or conflicting grain direction in wood.
2. Nicked or chipped cutter.
3. Feeding workpiece too fast.
4. Taking too deep of a cut.
5. Cutting against the grain of the wood.
1. Inspect workpiece for knots and grain direction;
only use clean stock.
2. Replace the cutter, or have it professionally
sharpened.
3. Slow down the feed rate.
4. Take a smaller depth of cut. (Always reduce cutting
depth when working with hard woods.)
5. Cut with the grain of the wood.
Divots in the
edge of the cut. 1. Inconsistent feed speed.
2. Inconsistent pressure against the fence and
rub collar.
3. Fence not adjusted correctly.
1. Move smoothly or use a power feeder.
2. Apply constant pressure; use proper hold-down
(
Page 38).
3. Adjust fence ( Page 25).
Operations