Woodstock ShopFox W1763W, Руководство пользователя, Страница: 29 / 64

-27-
Model W1763W (For Machines Mfd. Since 09/16)
O
PE
R
ATIO
NS
Figure.31..
Adjusting largest table insert
flush with table surface.
Two table inserts are provided, allowing for three
different opening sizes to be achieved. Use the smallest-
size opening for a cutter to reduce wood chips falling into
the machine. Using the smallest-size opening also covers
any unused portion of the bit below the surface of the
table, thus reducing the chance of operator injury.
The height of the largest insert can be adjusted to be
flush with the table. This is important to prevent the
table inserts from obstructing or shifting workpiece
movement while feeding.
Use a flat screwdriver and a straightedge to turn the
insert screws clockwise or counterclockwise to raise or
lower the insert until it is flush with the bottom of the
straightedge (see
Figure.31
).
Table.Inserts
Spindle.Elevation
Correct spindle height is crucial to most shaping
applications. We recommend using a piece of test wood
to confirm the correct spindle height before cutting
expensive wood.
To.set.spindle.height,.do.these.steps:
1..
Loosen spindle lock knob located on side of shaper
(see Figure.32 ).
2. Rotate spindle height handwheel (see Figure.32 )
clockwise to raise spindle or counterclockwise to
lower spindle.
3. Retighten spindle height lock knob on side of shaper.
DO NOT over-tighten this knob.
Note: Only a small amount of tension is needed to
keep spindle from moving during operation.
Figure.32.. Spindle height lock knob and
height handwheel.
Spindle
Lock
Knob
Spindle Height
Handwheel