Woodstock ShopFox W1763W, Руководство пользователя, Страница: 20 / 64

-18-
Model W1763W (For Machines Mfd. Since 09/16)
SE
TU
P
To.assemble.shaper,.do.these.steps:
1. With help from an assistant, carefully prop shaper
cabinet up on a block of wood so you can access under-
side of stand to install caster assembly.
2. Attach caster wheel assembly to stand with (3) M8-1.25
x 50 cap screws, 8mm flat washers, and M8-1.25 hex
nuts, as shown in Figure.11 .
3. Remove block of wood from under cabinet.
4. Unbolt control panel pedestal arm from cabinet, turn
rightside up, then re-attach.
5. Thread handle into handwheel, as shown in Figure.12 ,
and tighten it with a wrench.
6.
While an assistant holds extension wing in place,
attach it to the main table with (3) M10-1.5 x 35 cap
screws, 10mm lock washers, and 10mm flat washers
(see
Figure.12
).
7.
Place a straightedge across extension wing and main
table to make sure combined table surface is flat
(see
Figure.13
).
— If combined table surface is flat, skip to next step.
— If outside end of extension wing tilts down, use a
strip of masking tape along bottom edge of main
table to shim extension wing up (see
Figure 14).
Assembly
Figure.11. Installing caster assembly.
Figure 14 . Masking tape locations for
tilting extension table up.
Place Tape
Here
Extension
Wing
Figure.13.
Checking overall table flatness.
Straightedge
Before beginning the assembly process, refer to Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of the
heavy-duty rust-preventative applied at the factory, if
applicable. Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
Continued on next page
x 3
Figure.12.
Table extension wing hardware,
and spindle elevation handwheel.
x 3
Handwheel
Handle