Woodstock ShopFox W1763W, Руководство пользователя, Страница: 35 / 64

-33-
Model W1763W (For Machines Mfd. Since 09/16)
O
PE
R
ATIO
NS
Figure.45..
Fence setup for partial-edge
removal.
Direction Of Feed
End View
Always feed the wood against the rotation of the cutter as
shown in
Figure.45.
Another way to conceptualize this is
to always feed the wood into the cutter so that the cutter
is pushing against the direction of feed. Never feed wood
in the same direction as the cutter rotation. This is called
a “climb cut” and is extremely dangerous, as workpiece
can become uncontrollable and kick back.
Also, examine the grain on the side edge of the board.
Whenever possible, run the board so the shaper cutters
are cutting with the grain, as shown in Figure.45 . This
will minimize the chance of tear out.
For.partial.edge.removal,.do.these.steps:
1.
Loosen fence lock knob (see
Figure 43
).
2.
Turn fence adjustment knob and adjust infeed fence
until workpiece contacts cutter at desired location.
3. Tighten fence lock knob to secure fence position.
4.. Adjust outfeed fence so that it comes into alignment
with infeed fence, as shown in
Figure.45
.
5..
Now place a straightedge against both faces of
fence to check alignment. Once they are both in
alignment, make sure lock knob is tightened.
Perimeter.Cutting
When a workpiece requires all sides to receive a shaped
profile, it is important to begin with the end grain sides
before cutting the long grain side. As a cutter approaches
the edge of end grain, a small amount of tear-out will
commonly occur. By running end grain edges first, the
tear-out is removed when long grain cuts are completed.
Completing cuts in multiple passes (when possible) rather
than one heavy cut, will often produce cleaner results and
can prolong cutter life.
To.cut.an.edge.around.workpiece.perimeter,.do.these.
steps:
1.
Cut workpiece (sides 1 & 2) with end grain first (see
Figure 46 ).
2. Cut sides with grain (sides 3 & 4) last, or in
sequence, as shown in
Figure 46
.
Below
NOT
RECOMMENDED
Figure.46.. Sequence for shaping an edge
around a workpiece.
Partial.Edge.Removal