Woods Batwing BW10.70E, Руководство оператора

Страница: 16 / 151

16 Owner Service
MAN1258 (3/26/2018)
Do not attempt to mount a tire unless you have the proper equipment and
experience to perform the job.
Always maintain the correct tire pressure. Do not inflate tires above the recom -
mended pressure. Never weld or heat a wheel and tire assembly. The heat can
cause an increase in air pressure and result in a tire explosion. Welding can
structurally weaken or deform the wheel.
When inflating tires, use a clip-on chuck and an extension hose long enough to
allow you to stand to the side — not in front of or over the tire assembly. Use a
safety cage if available.
Check wheels for low pressure, cuts, bubbles, damaged rims, or missing lug
bolts and nuts.
Never remove split rim assembly hardware (A) with the tire inflated.
Figure 8
. Split Rim Tire Servicing
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass, crop residue, etc.
from machine.
●
Inspect machine and replace worn or damaged parts.
●
Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass, crop residue, etc. from
machine.
●
Remove the remainder using a low-pressure water spray.
1.
Be careful when spraying near scratched or torn safety decals or
near edges of decals as water spray can peel decal off surface.
2.
Be careful when spraying near chipped or scratched paint as water
spray can lift paint.
3.
If a pressure washer is used, follow the advice of the pressure
washer manufacturer.
●
Inspect machine and replace worn or damaged parts.
●
Sand down scratches and the edges of areas of missing paint and coat
with Woods spray paint of matching color (purchase from your Woods
dealer).
●
Replace any safety decals that are missing or not readable (supplied free
by your Woods dealer). See Safety Decals section for location drawing.
A
PN 1006348