Setup & Operation
Loading, Turning, And Clamping Logs
Setup & Operation
HDSdoc021716
2-23
2
To Clamp Logs
1.
Raise the clamp up/down lever to raise the clamp.
2.
Raise the clamp in/out lever and clamp the log against the side supports.
3.
Lower the turner lever until the turner arm falls below the bed.
4.
Use the clamp in/out lever, gently release the clamp.
5.
Lower the side supports, to make few cuts.
6.
Use the clamp in/out lever to clamp the log.
Depending on the log length, front and rear clamp (min. log length - 3.5m), or main clamp together with front
or rear one (with logs shorter than 3.5m) can be used . They allow to find optimal position of the log on the
bed, and prevent distortions during cutting.
1.
Raise the front/rear clamp up/down lever to raise the clamp.
2.
Raise the front/rear clamp in/out lever to clamp the log.
3.
Use the middle clamp in/out lever to clamp the log against the side supports.
4.
Lower the front/rear clamp up/down lever to lower the clamp, until the log lays flat on the bed.
To Level A Tapered Log
Use the toe board lever(s) to raise either end of a tapered log, if desired. Log can be moved forward or
backward using the power roller.
Raise the appropriate lever to raise the front or rear toe board until the heart of the log measures the same
distance from the bed rails at each end of the log.
Содержание LT70M AH Super
Страница 1: ...Table of Contents Section Page Table of Contents SW 07doc0217161...
Страница 2: ......
