PG
17
OF
24
M0183.05 JULY 2019
Whatcom Gas-Fired Vertical Rotisserie CE
Installation and Operation Manual
CLEANING
CLEANING THE ROTISSERIE CABINET EXTERIOR
All exposed surfaces of the rotisserie should be wiped clean as necessary (or daily) using an approved mild cleaning solution�
Be careful not to get excess liquid into any of the switches or controls�
Stubborn residues may be removed using a non-metallic scouring pad�
When scouring stainless steel, scrub with the grain to avoid scratching the finish�
CLEANING THE GLASS
Use hot soapy water to remove most of the grease splatters, then an appropriate glass cleaner to clean the glass�
Do not
use
any abrasive cleaners or pads on the glass doors�
CLEANING THE ACCESSORIES
All rotisserie attachments (spits, forks, etc�) should be cleaned between uses using an approved mild detergent, hot water and
sanitizing agent� Alternatively, these items can be cleaned in a dishwasher�
ROUTINE CLEANING OF THE ROTISSERIE CABINET INTERIOR
See next page for illustrated version of these instructions.
Pull out the drain stand pipe and allow the water to flow down the drain�
Remove the two Infrared (IR) Burner Reflectors at the base of each side IR Burner for cleaning�
Lift the center Flame Post Guard straight up off the Flame Post�
Scrape, if necessary, then wash by hand or in dishwasher�
With a warm damp cloth, wipe up any grease remaining in the cabinet�
Then use a clean dry cloth to dry and polish the surface�
IMPORTANT: Do not to get liquid onto the center Flame Post Jets, the side Infrared Burners or the Igniters.
Be careful not to wipe or spray onto the Infrared Burners or Jets�
Do not touch or attempt to clean the Igniters located near the top of each burner�
The Flame Post Guard must be lifted off of the center Flame Post for cleaning�
NOTE:
The Flame Post should never
be wiped down or cleaned in place as the jets will clog� The correct way is to always lift the Flame Post Guard off the
center post and manually wash while it is off the center post� When replacing Flame Post Guard, be careful to line
up the holes correctlly with the Jets�
Front of unit
Detail: Curb Walls
q
w
e
w
PERIODIC CLEANING UNDER COUNTERTOP MODELS
The 4" Curb Walls at the base of the unit can be removed in
the order indicated below: front, sides and then rear�
Each of the four walls is secured by two screws�
