Setup and Operation
One-person operation
3
3-4
doc011422
Setup and Operation
See Figure 3-2.
13.
Use the air valve to adjust the table approximately one board thickness plus 1/4 inch (6
mm) below the blade.
Air valve controls: Neutral is the 3 o’clock position. Raise the han
-
dle up to raise the table; lower handle to lower table. Always return
the handle to the neutral position.
14.
Place half the pallet over the blade and lower the pallet so the blade is positioned
between two deck boards. (See figure 3-2.)
15.
Pull the pallet away from the blade.
NOTE:
Move the pallet from side-to-side as you pull to ease the
cut.
16.
Lift and rotate the pallet to remove the other half of the boards.
17.
Turn the pallet over and repeat Step 14. through Step 16.
18.
Remove the last board by pulling the stringers from left to right.
FIG. 3-2
DM201-1
Set table one board
thi 1/4 inch
below blade
Air Valve