SETUP & OPERATION
Chain transmission with trapezoidal thread adjustment
3
3-9
EGdoc121819
3.2.3 Chain transmission with trapezoidal thread adjustment
The chain used to raise and lower the table, must not be slack, but needs to be tensioned enough
that teeth mesh correctly.
The chain tension is adjusted with the nut located on the planer/moulder base, under the outfeed
table.
Do not adjust the chain tension, when table is raising or lowering. In this case incorrect chain tension
can mean that chain has disconnected.
3.2.4 Variable speed motor manual
WARNING!
Do not turn feed speed adjustment knob when the feed is
off or material is planing/moulding.
ASSEMBLY (IF VARIABLE SPEED MOTOR IS MOUNTED IN PLACE)
Mount feed motor on the last feed roller. Be sure the torque is constant. Use the lock screw to secure
the motor on the roller.
SETTING THE FEED SPEED
To set the feed speed use the knob located on the feed gear. To increase the speed turn the knob
right, to decrease - turn left.
MAINTENANCE
Fluid should be visible in the fluid inspection window. Fluid level should be checked when feed gear
is not working.
Fluid should be refilled when it is not visible in the inspection window. Use oil for automatic
gearboxes or compatible oil according to the table below.
The variator is filled with AGIP BLASIA 32 at the factory and does not normally require an oil change
during its life.
The worm gear oil does not normally need changing or topping up during the life of the gear.
See table 3-2.
Recommended oil types.
AGIP
BLASIA 32
SHELL
A.T.F DEXRON
ESSO
A.T.F DEXRON
MOBIL
A.T.F 220
CASTROL
DEXTRON II
BP
AUTRAN DX
TABLE 3-2
Содержание MP160
Страница 2: ......
