Operation
Programming board and cant thicknesses (possible only when REF1, REF2, PAT1, PAT2 or
Operation
doc042607
4-13
4
2.
You will enter the
Setup
function (Edit Mode).
3.
Push the top button on the right joystick (end MEMORY BANK button if desired) as many
times as necessary to access the board thickness (storage cell) you want to change.
When PAT1 or PAT2 is active, you can use this button also to switch between Cant
thicknessses in the following sequence: Board1, Board2, Board3, Cant1, Cant2.
4.
Pulling the left joystick toward you or pushing it away from you, you can increase
or decrease the board thickness setting in 1mm increments. When you hold this joystick
for about 2 seconds after pushing it in the appropriate direction, the board thickness value
will be increasing or decreasing continuously (fast).
5.
Push and hold the top-right joystick button again for about 3 seconds to exit the
Setup
function (Edit Mode). From now on the modified board thickness value is stored in the
computer memory.
