SETUP
Max Head H (upper saw head travel limit)
SETUP
doc100206
3-11
3
See Figure 3-4.
3.7.2
Max Head H (upper saw head travel limit)
The Max Head H (upper saw head travel limit) is programmable (from 100mm to 885mm,
the maximum height allowed by the length of the sawmill mast). This option is useful
when the area where the sawmill is installed does not have enough height clearance to
allow the saw head to travel to the top of the mast (to the height of 885 mm). In that case
the upper head travel limit can be set to a lower height to ensure smooth sawmill
operation.
3.7.3
PF adjustment (power feed dial calibration
)
Calibration of the power feed dial is to set its range of operation, i.e. points of maximum
and minimum saw head speeds (how many degrees the dial has to be rotated through to
increase the saw head speed from the minimum to the maximum and vice versa).
This setting determines sensitivity of the dial.
FIG. 3-4
ac_s002
Last Cut
