Wood-mizer LT35, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 54 / 134

Sawmill Operation
Preparing The Sawmill For Towing
4
4-17 WMdoc072619 Sawmill Operation
1. Move the saw carriage to the front end of the sawmill. Raise the rear outriggers.
CAUTION! Be sure the outrigger base is adjusted properly before
securing the FAO in position with the lock pin. Failure to do so will
cause damage to the outrigger grease fitting.
CAUTION! Do not adjust the FAO outrigger base height while there is
weight on the FAO. Damage to the FAO may result.
2. If the sawmill is equipped with the optional hydraulic log turner, use the hydraulic control
to raise the turner arm as high as it will go. Lift the turner arm up and place the travel plate
under the turner to secure the arm above the sawmill bed.
CAUTION! Move the optional hydraulic turner to provide maximum
ground clearance before towing. Failure to do so may result in damage
to the sawmill.
3. If the sawmill is equipped with the optional hydraulic log loader, remove the loader retain-
ing pins and use the hydraulic control to raise the loader as high as it will go. Place the
retaining pins in the towing position holes and push the loader lever down to bring the
loader arm channels up to the loader.
See Figure 4-11.
4. Release the blade tension.
FIG. 4-11
Towing Position
Operation Position
300133
Lock Pin