Wood-mizer LT35, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 32 / 134

Sawmill Setup
Portable Sawmill Setup
3
3-6 WMdoc072619 Sawmill Setup
CAUTION! Always make sure the engine is running before operating
the sawmill controls. Operating the controls without the engine running
will result in power drainage from the battery.
5. Remove the fenders by lifting them out of the slots.
CAUTION! To prevent fender damage, remove fenders before operat-
ing sawmill or loading logs.
6. Use the feed control switch (left side of control box) to move the cutting head toward the
front end of the mill.
7. Lower and set the remaining rear outriggers. Level the sawmill by adjusting the outriggers
to raise or lower each end of the sawmill. Adjust all outriggers evenly to avoid twisting the
mill frame by jacking one outrigger higher than the others.
For FAO(s), fine tune the outrigger base height as necessary. Move the cutting head to
the opposite end of the mill from the outrigger. Raise the entire outrigger (to remove the
sawmill weight from it) and adjust the outrigger base as necessary. Lower the entire out-
rigger and use the locking pin to secure in position.
CAUTION! Do not adjust the FAO outrigger base height while there is
weight on the FAO. Damage to the FAO may result.
8. Raise the two side supports to prevent the log from falling off the side of the mill when
loaded.
See Figure 3-7.
FIG. 3-7
SM0130B
Bed Rail
Stop Block
Pivot End Rail
Side Support