Sawmill Alignment
Blade Guide Arm Alignment
Sawmill Alignment
WMdoc072619
7-22
7
See Figure 7-21.
Blade Guide Arm Alignment
The blade guide arm moves the outer blade guide in and out. If the arm becomes loose,
the blade guide will not deflect the blade properly, causing inaccurate cuts. A loose blade
guide arm can also cause blade vibration.
1.
Adjust the blade guide arm out to 1/2" (13 mm) from fully open.
See Figure 7-22.
Use the inside top and bottom screws to adjust the arm up until the
slide pad touches the saw head brace tube. Tighten the jam nuts.
FIG. 7-21
FIG. 7-22
Tilt Adjustment
Screws (4)
3H0802-15
Blade Guide
Shaft Centered
In Block
Top Vertical
Adjustment Jam Nut
Bottom Vertical
Adjustment Jam Nut
Roller Flange
280011
Adjust inside top
and bottom screws
with arm
open
Adjust outside top
and bottom screws
with arm closed
Содержание LT35
Страница 127: ...Electrical Information Engine Harness Wiring D24 Electrical Information 35doc072619 9 5 9 3H1220 2 ...
Страница 128: ...Electrical Information Engine Harness Wiring D24 9 9 6 35doc072619 Electrical Information 3H1220 3 ...
Страница 129: ...Electrical Information Engine Harness Wiring D24 Electrical Information 35doc072619 9 7 9 3H1220 4 ...