Sawmill Alignment
Complete Alignment Procedure
7
7-33
30S97doc041910
Sawmill Alignment
Bed Rail Adjustment
1.
Install the log clamp at its lowest setting in a hole where the clamp is positioned 10" from
the clamp stop (fourth hole from stop). Move the saw head until the blade is centered over
the clamp. Raise the saw head until the blade measures 14 1/2" (360 mm) from the top of
the clamp. Use a rule to determine the actual distance of the blade to the clamp.
See Figure 7-28.
2.
Adjust the front pivot rail 90° to the main bed tube.
3.
Move the saw head to center the blade over the front pivot bed rail.
4.
Measure the distance from the top of the pivot rail to the bottom of the blade. Make this
measurement at each end of the pivot rail.
5.
The two measurements should be 15" (375 mm) (+1/32 [0.8 mm] -0).
FIG. 7-28
