SETUP & OPERATION
Grinding Wheel Installation
SETUP & OPERATION
BMS500/600doc121319
2-6
2
2.4
Grinding Wheel Installation
Use a Wood-Mizer approved grinding wheel. To install the grinding wheel, perform the following
steps:
1.
Push the START button
on the control box and turn the feed rate dial clockwise to rotate the
cam.
2.
Rotate the cam until the sharpener head is raised all the way up. Turn the feed rate dial all the way
down and push the STOP button
.
3.
Dismount the oiler.
4.
Remove the grinding wheel side guard.
5.
Remove the nut and the grinding wheel clamping plate from the spindle shaft.
6.
Slide a grinding wheel onto the spindle shaft.
7.
Install the grinding wheel clamping plate.
8.
Tighten the nut to 44.2 ft-lbs (60Nm) torque.
9.
Install the grinding wheel side guard.
10.
Mount the oiler.
DANGER!
Make sure all guards and covers are in place and secured
before operating the sharpener. Failure to do so may result in serious
injury.
2.5
Blade Installation
1.
Uncoil a blade and position it on the inside of the rear support arms and on the outside of the blade
support guide assemblies located on the side support arms.
2.
Place the blade between the blade wiper plates and the blade clamp plates.
3.
Make any final adjustments to the support arms and guide assemblies to ensure the blade band
rests evenly on both, the right and left blade height asjustment pins. Make sure the blade does not
touch the bottom of either side guide assembly.
Make sure the guide assemblies lean slightly in the direction the blade travels through them.
4.
Rotate the pivot arm of the deburr assembly so that the carbide cutting plate touches the blade.
