Wood-mizer A/DH5, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 64 / 134

SETUP & OPERATION
Blade Height Scale
2
2-30 doc111517 SETUP & OPERATION
3. Clamp the flitches against the side supports. (Wider flitches should be placed to the clamp side.
When they are edged, flip them over to edge the second side without disturbing the other flitches or
without having to pull them from the middle of the stack.)
4. Adjust the blade height to edge a few of the widest boards.
5. Loosen the clamp and turn the edged boards over to edge the other side.
6. Repeat steps 2-4.
7. Loosen the clamp and remove the boards that have good clean edges on both sides. Clamp the
remaining flitches and repeat steps 2-5.
2.16 Blade Height Scale
See Figure 2-23. The blade height scale is attached to the cutting head frame.
It includes:

a blade height indicator

an inch scale.
Blade Height Indicator
The blade height indicator has two horizontal, red lines on both sides. Readings should be taken with
eyes level with the indicator, when the two red lines are in line. This will allow to avoid the parallax
error (different scale readings depending on the angle of vision).
The Inch Scale
The horizontal red line on the blade height indicator shows how many inches the bottom of the blade
is above the bed of the mill. If you know the height of your blade at each cut, you can determine the
thickness of lumber you are sawing.
FIG. 2-23
Quarter
Scale
1 6
1 7
1 8
1 4
4
4
4
5
5
5
5
6
6
6
8
1 5
4
8
Inch
Scale
Blade Height
Indicator
Quarter
Scale
Blade Height
Indicator
Inch
Scale