SETUP & OPERATION
Portable Sawmill Setup
SETUP & OPERATION
doc111517
2-13
2
3.
Remove the fenders by lifting them out of the slots.
CAUTION!
When setting up the sawmill on boggy terrain (such as
deep mud or sand), place a board or a metal plate under each
outrigger leg to prevent the legs from sinking.
4.
Unhook the carriage safety chain, located at the bottom of the vertical mast.
5.
Use the up/down switch to raise the cutting head from the carriage rest pin. Remove the distance
block from the stop bolt.
See Figure 2-11.
WARNING!
Put front outrigger down before moving cutting head from
the rest position.
CAUTION!
To prevent fender damage, remove fenders before
operating sawmill or loading logs.
6.
Use the power feed switch to move the cutting head toward the front or the rear end of the mill.
Lower and set the remaining rear outriggers.
7.
Level the sawmill by adjusting the outriggers to raise or lower each end of the sawmill. Adjust all
outriggers evenly to avoid twisting the mill frame by jacking one outrigger higher than the others.
FIG. 2-11
Distance Block
Stop Bolt
Содержание A/DH5
Страница 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Страница 2: ......
Страница 41: ...SETUP OPERATION Sawmills with cable guide SETUP OPERATION doc111517 2 7 2 FIG 2 4 LT40MRC K 7 B5 1 B0 18...
Страница 86: ...1 18 30doc111517...
