Wolf Garten Robo Scooter 1800, Оригинальная инструкция по эксплуатации

Страница: 75 / 362

16
Chapter 3 Preparing the Unit
Before using the unit for the first time, you have to perform some
simple preliminary settings. Once preparations are complete, your
unit will be ready to mow your lawn.
3.1 Adjust the Cutting Height
Blade Cutting Range: 20 – 80 mm (0.8 – 3 inches)
To adjust the cutting height of the blade, do the following:
P
Lift the Door panel at the top of the mower.
P
Turn the knob (A) while pushing it down.
)
To raise the cutting height, turn Anti Clockwise.
)
To lower the cutting height, turn Clockwise
P
The cutting height (B) is displayed to the left of the knob (A).
3.2 Insert the Fuse
Your unit is shipped with the fuse removed.
The fuse is packed in a plastic bag attached to the top
of the mower.
P
Remove the fuse from the small plastic bag provided.
P
Unscrew the fuse holder (C) from the mower.
P
Place the fuse into the fuse holder.
The fuse can be inserted in either direction.
P
Insert the fuse with holder back into the mower, and screw until
fully closed.
The unit will now power up (wake up).
The batteries are sufficiently charged to allow for performing
the One-Time Setup.
3.3 One-Time Setup (Step By Step)
Once the fuse is inserted, we are ready to perform the One-Time
Setup process.
P
Make sure the Power Box is plugged in.
P
Place the unit inside the lawn, approximately 3 m (10 ft.) in
front of the Base Station, facing the Perimeter Wire.
Use the buttons on the Front Panel as follows:
P
Press the arrows until your selection is displayed.
P
Press to select the value shown on the display.
P
Press to go back or to cancel.
A B
C
Front Panel buttons
75
en