Wolf Garten Robo Scooter 1800, Оригинальная инструкция по эксплуатации

Страница: 70 / 362

11
Initial Setup
)
Leave the four pegs 4 – 7 standing half-way out.
)
They will later be connected to the wire after you finish
setting the Perimeter Wire around the Sub-Zone.
P
Complete setting Perimeter Wire around the Sub-Zone until
you come back to peg #4.
P
Lay the Perimeter Wire through pegs 4 – 7 in sequential
order. Insert the pegs all way to the ground, to keep the wire
attached to the ground
)
Lay the wire along the Narrow Pass parallel to the first
wire.
)
Maintain a 14 cm (0.5 ft.) distance between the wires in
the pass.
P
Back at the pass entrance: Lay the wire through remaining
pegs 5 , 6 , 7 .
)
Insert the pegs all way to the ground, to keep the wire attached to
the ground.
P
Resume laying the Perimeter Wire in the Main Zone towards the Base
Station.
2.3 Separated Zone(s)
If the lawn has one or more zones that are separated and if the mower
cannot drive from one zone to the other, an additional setting is required.
In such cases, the mower will have to be driven or carried between the zones.
A minimum of 1 m (3.3 ft.) must be kept between the wires of the
Separated Zone and the Main Zone.
2.3.1 Setup for a Separated Zone that can be
completely mowed in a single operation
(200 m²/2150 ft² for the RS630 and
100 m²/1100 ft² for all other models)
P
If possible, the separated area may be
connected to the main area’s Perimeter Wire.
)
No special accessories are needed.
P
If the areas cannot be connected to the
Perimeter Wire of the Main Zone.
)
The Separated Zone will have its
own Perimeter Wire.
)
The Perimeter Wire will be connected to an additional Perimeter
Switch (Optional accessory).
)
Install the Perimeter Switch according
to instructions boxed with the
Perimeter Switch accessory.
)
Set a Perimeter Wire in the Separated Zone.
2.3.2 Setup for a Separated Zone that
requires more than a single operation to
completely mow the area
P
Additional separate Station, including a
Power Box (optional accessories) are
required for this installation.
P
Install the station according to instructions
boxed with the separate Base Station.
P
Set a Perimeter Wire in the Separated Zone.
Lay the Perimeter Wire through
Main Zone
Sub-Zone
Ending the Sub-Zone passage setup
Separated Zone smaller than
200 m² (2150 ft²)
Main Power
Box & Base
Station
Additional
Perimeter
Switch (Optional
accessory)
Separated Zone larger
than 200 m² (2150 ft²)
Main Power
Box & Base
Station
Optional Power Box
& Base Station
70
en