Wohler AMP1-S8DA, Руководство пользователя

Страница: 51 / 76

82 10 30 : A MP x-S 8 S e r ie s U se r G u id e
© 20 13 Wo hl e r Te c hn ol og i e s , In c . A l l r ig h ts re se rv ed .
39
C h a p t er 4 Presets
M e t h o d s o f A cc e s s i n g t h e Pr e s e t s
Enabling/Disabling Preset Mode
To enable or disable
Preset
mode:
1. Press
Fn+Setup
.
2. Use the
Up
and
Down
arrow buttons until PSet Mode PSet Mode PSet Mode PSet Mode appears in
the LCD window and press
Enter
.
3. Press the
Up
and
Down
arrow buttons to toggle between Disa Disa Disa Disa
(disabled) and Ena Ena Ena Ena (enabled). Press
Enter
to accept the new
setting, or press
Escape
to cancel the change. Either way, you will
be returned to the
Setup
menu.
4. Press
Escape
again to return to normal operation.
Recalling a Preset
If Preset mode is enabled, press Input to recall the first available
preset. Subsequent presses will cycle through all the available presets.
Speaker Assign/Preset Buttons (Presets 1 through
4 Only)
Presets 1 through 4 get special attention. You can recall, save, or
overwrite them simply by pressing
Fn+Preset x
(where x represents
the corresponding Speaker Assign button immediately above or
below the meters on the left side of the unit). In the following examples,
we’ll be using Preset 1.
Note: When this mode is enabled, you can no longer directly select
the inputs by the input type (e.g., AES 1, SDI 2, analog, and
so on). The inputs are accessed only indirectly through the
presets in this mode. To access the inputs by input type, you
must first disable
Preset
mode.
Note: This selection will not appear if all the presets are
empty. In this case, you will need to store at least one
preset to enable this menu item.
USO
RESTRITO