Page 26
a.
Source Select
: The
Source
knob will select the input source to be
monitored.
b.
All Presets
: The
Source
knob will select between any Presets present
in the unit.
c.
Favorite Presets
: The
Source
knob will select between any of the
Favorite Presets present in the unit.
d.
No Operation:
The
Source
knob will perform none of the above listed
selection operations. If the
Source
knob is set to
No Operation
and
is turned, the Audio Meters screen will display
for 3
seconds at the top center, as a reminder.
Note
: Regardless of the
Source Knob Selection
, the
Source
knob is
used to select clusters when in the Loudness Meter Screen.
Touch
Back
to exit this menu.
Phase Configuration
Touching the
Phase Config
selection on the
Unit Settings
Menu proceeds to the
Phase Config Menu
. This menu is shown in Figure 2-18.
Figure 2-18: Phase Configuration Menu
Phase Config
Save & Exit
Cancel & Exit
Pair - 1
Pair - 3
Pair - 5
Pair - 7
Off
Pair - 2
Pair - 4
Pair - 6
Pair - 8
On
On
On
On
On
On
On
The controls function as follows:
1.
Pair 1 - 8
: These switches allow you to select which channel pairs will
receive a phase meter on the
Metering Screen
. Generally, it is useful to
monitor the relative phase of stereo pairs. However, sometimes each
channel of a pair is unrelated to each other. This can be because the
channels are used to convey two independent monophonic signals or that
one channel may be a Center channel and the other may be a Low Frequency
Effects channel. In these instances, the Phase Indicator would almost always
indicate an out of phase condition. Because this would be a needless
distraction to the operator, switches are provided on this screen to
individually turn phase monitoring for each channel pair on or off.
2.
Cancel & Exit
: If you decide that you do not want to keep the settings you
