To connect to the website, enable access to the router's IP address in the browser (from the
computer on the USB network interface it should always appear as
192.168.10.10
IP address,
Subnet mask: 255.255.255.0 - this is set in
Control Panel / Network and Sharing Center /
Adapter Settings / Under Network Connections
, to the
USB Ethernet / RNDIS Gadget
Interface
.)
If the router is not starting
It is possible that there is no uploaded software available on the router. Upload the router software
or ask our support line!
Periodic restart of the router (by 10 minutes periods)
When router was not be configured properly for the ppp/wan connection or the modem was not
started then the router will be restarted within in 10 minutes.
You can also configure the periodic ping interval from the LuCi / OpenWrt.
Restart of the router
If the router is not responding permanently, you can restart it by disconnecting power cable
(
POWER
titled microfit connector) then after a few second plug it again. The LEDs must assign the
presence of the power source.
Shutdown / halt the router
To shutdown the router, first you have to reboot by the
System / Reboot
menu. When all the
three LEDs blinks at once, the router is restarted and can be switched off safely as soon as you can
–
pull out the power connector from electricity plug.
Attention! Never stop the router without requesting the reboot process, and do not
remove the power socket without restarting the router before this action!
Antenna
Check or connect proper SMA fit antenna to the
Antenna
connector and mount it to the interface.
In case of presence of two antenna connectors, the left antenna is the
MAIN
, the secondary is the
DIV
(diversity).
The router must send and assure proper RSSI signal value and life signals.
Always use the antenna type regarding to the used module and mobile network, bandwith. In case
of using 4G connection and module, you need two 4G antennas (Main and Diversity)!
