Wirepath Surveillance WPS-500-PTZ-IP, Инструкция по установке и эксплуатации

Страница: 45 / 56

WPS-500-PTZ-IP Installation Manual
Pg. 45
www.snapav.com Support: 866.838.5052
12.13- I/O Settings
Use this menu to configure the Cameras Contact & Relay connections.
12.13.1- Input Settings
DI Sensor State N.O
Camera expects contact closure connected to the DI input to be normally
Open. An Event is triggered when the contact is closed.
N.C Camera expects contact closure connected to the DI input to be normally
Closed. Event is triggered when the contact is open.
Send To If notification or logging is desired, select the destination to send it to when the DI
input event is triggered.
Subject
Enter a name to use to identify the event.
Interval Selects the time to wait between input events before another event can be triggered.
Only at
Schedule Times When selected, events will only be monitored based on a configured schedule.
Scheduling must be Enabled for this feature to work.
See section
12.12-Schedule .
12.13.2- Output Settings
Mode Setting
Open/Close
Manually Device connected to the DO output can be triggered from
the browser GUI or configured Events only.
Open/Close at
Interval DO output will be cycled between Open and Closed at the
Interval configured below.
Interval
Select the interval between DO output Open and Close when Mode Setting is
“Open/Close at Interval”.
12.14- Log List
Access to the logs for various actions of the Camera.
System Log
Displays System level events such as logins and configuration changes. This log is maintained even
through loss of power.
Motion Detection Log
Displays Motion Detection events. This log is NOT maintained when power is lost.
Input Trigger Log
Displays Motion Detection events. This log is NOT maintained when power is lost.
All Logs
Displays a combined list of all currently available log files.