SECTION 6
ELECTRICAL
6-2
The power cord is designed to ground the
electrical system through the receptacle. It is also
designed to carry the amperage output of most
campground outlets. If the electrical receptacle to
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Connecting The Power Cord
To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable 50-amp power receptacle to provide
external power to the coach and converter/
charger system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
A flip-down hatch lets you route the power
cord out the bottom of the compartment so you
can close the compartment door while the power
cord is connected.
1. Flip the hatch downward.
2. Swivel the cover section aside to reveal cord
notch.
3. Route the cord through the notch and flip the
hatch back up into place and close the com-
partment door.
WARNING
Do not connect the external power cord to
any receptacle until you have contacted
the owner and/or attendant of the
premises to verify proper polarity and
grounding.
It is the responsibility of the owner of the
electrical receptacle to ensure that the
receptacle is properly wired and
grounded.
Reverse polarity and improper grounding
of the vehicle can cause personal injury or
death.
50 Amp.
Power Receptacle
