10-5
SECTION 10
SLIDEOUT/LEVELING
NOTE:The hydraulic pump is equipped with two
types of hydraulic solenoid valves shown.
The leveling jack solenoids have a T-
handle on the valve shaft that can be
turned by hand. The slideout room
solenoid has a small 1/4” nut at the end
of the valve shaft that requires you to use
a 1/4” nut driver built into the shaft of
the oil reservoir breather/fill cap.
See the Leveling System/Room Extension
Operator’s Manual in your InfoCase for
specific instructions on which valves to
open for front or rear slideout rooms and
what additional precautions to follow.
NOTE:Always clean away any dirt and debris
from the top of the reservoir before
removing the breather cap to avoid entry
of debris and contamination of hydraulic
oil in the reservoir, which could lead to
pump failure or other problems.
•
Open the slideout solenoid valves (with 1/4”
nuts on the ends) to relieve hydraulic line
pressure.
DO NOT LOOSEN NUTS MORE
THAN 4 FULL TURNS.
•
Do not open any of the four large T-handled
valves. These control the coach leveling jacks
.
Step 2 - Crank the Room Inward
•
A wrench is used to crank the room inward.
You may use the ratchet wrench supplied with
the coach (in one of the storage
compartments) or any type of wheel lug
wrench for the same size bolt head.
Hydraulic Pump beneath Entry Step
Use 1/4” nut driver built into end of pump
reservoir cap to open slideout solenoid valves.
Leveling/Slideout System Hydraulic Pump
(Note valve positions in relation to fluid reservoir)
Use provided 1/4” nut driver to turn nut
counterclockwise 4 turns only.
Slideout Room Solenoid Valve
